mirror of
https://github.com/tylernguyen/x1c6-hackintosh.git
synced 2025-02-05 09:33:13 -06:00
32 lines
2.8 KiB
Markdown
32 lines
2.8 KiB
Markdown
# Hardware and BIOS:
|
|
|
|
> ## PM981:
|
|
For installation on the factory drive `PM981`, please refer to [Issue #43](https://github.com/tylernguyen/x1c6-hackintosh/issues/43).
|
|
|
|
> ## WiFi and Bluetooth:
|
|
|
|
Replace factory Intel WiFi module with a macOS compatible one. Make sure that the card is of M.2 form factor. I replaced it with the BCM94360CS2 card. This works out of the box without additional kexts and has been stable for me thus far.
|
|
|
|
**If your laptop did not come with WWAN, you can purchase additional antennas to add to your laptop. This is useful when using WiFi/Bluetooth cards that have 3 antennas.**
|
|
|
|
- The BCM94360CS2 module comes from the 2013 MacBook Air, supports BT 4.0 and 802.11a/g/n/ac. They run on eBay for <\$15.
|
|
- For the BCM94360CS2 to work with the x1c6, you would also need a M.2 NGFF adapter. They run for <\$10 on eBay under "BCM94360CS2 m2 adapter"
|
|
- Above is my current setup.
|
|
|
|
However, there exists other alternatives with better WiFi and Bluetooth standards, but additional kexts are required. See [`dortania/Wireless-Buyers-Guide`](https://dortania.github.io/Wireless-Buyers-Guide/).
|
|
|
|
> ## BIOS Settings:
|
|
|
|
At the minimum, these BIOS settings must be made to install and run macOS without any problems:
|
|
|
|
| Main Menu | Sub 1 | Sub 2 | Sub 3 |
|
|
| --------- | ----------- | --------------------------------------------- | ------------------------------------------------------------------ |
|
|
| Config | >> Security | >> Security Chip | Security Chip `DISABLED` |
|
|
| | | >> Fingerprint | Predesktop Authentication `DISABLED` |
|
|
| | | >> I/O Port Access | Wireless WAN `DISABLED` \*ENABLED if you have a 2nd drive attached |
|
|
| | | | Fingerprint Reader `DISABLED` |
|
|
| | | >> Secure Boot Configuration | Secure Boot `DISABLED` |
|
|
| | | | Press `Clear All Secure Boot Keys` |
|
|
| | | >> Intel SGX | Intel SGX Control `DISABLED` |
|
|
| | >> Startup | UEFI/Legacy Boot `UEFI Only` | |
|
|
| | | CSM Support `No` (per OpenCore Documentation) | |
|